August 18, 2006

Well, I figured that I had better get to the parts that I built this table for. The elevator and stabilizer spars are both about ten feet long. I haven't done the main fin spar yet either. I started with the forward stabilizer spar because it's relatively short and has no tapering. The printer I've been using at work to make my templates is broken so I just laid this out by hand. For the spars, this is relatively easy to do. I drew the centerline and measured where the crosspieces go. At each crosspiece, I measured out the width. I drew the layout yesterday, and carved out all the pieces and glued it down today.

  |   Tail Parts Menu   |   Home